Flooring Solutions

Confirm slip performance, substrate stiffness, movement joints and finished floor height. Tiles and grout alone do not form a waterproofing system. Natural stone may need sealing and product-specific cleaning; outdoor and wet-area suitability must be checked.

Use a compatible cleaner, maintain grout and movement joints, and reseal stone where the selected system requires it.

Moisture, acclimatisation, subfloor ventilation and movement allowances matter. Sanding potential depends on the remaining wear layer and product. Confirm installation method, heating compatibility and commercial use rating; timber is not a default choice for standing water.

Remove grit, use furniture pads and clean with a lightly damp mop and the recommended wood-floor cleaner. Avoid soaking or steam cleaning unless expressly approved.

Water resistance varies by product and does not make every installation waterproof. Check edge detailing, perimeter gaps, underlay, subfloor flatness and door clearances. Laminate cannot normally be sanded back like timber.

Vacuum or sweep grit and wipe up spills promptly. Use the specified low-moisture cleaning method and protect against dragged furniture.

A water-resistant board is not a waterproof room. Check substrate flatness, expansion requirements, direct-sun temperature limits, underlay compatibility and loads from fixed joinery. Building-specific acoustic requirements need separate verification.

Sweep regularly, use a compatible damp-cleaning method and protect against grit and heavy furniture. Follow product limits for heat and cleaning equipment.

A smooth, dry substrate is especially important because imperfections may show through. Confirm adhesive, indentation resistance, rolling loads and slip requirements. Welded seams and wet-area details need a specified compatible system.

Remove grit and use the manufacturer-approved cleaner and pads. Avoid harsh solvents and check compatibility of rubber-backed mats.

Match fibre, pile, backing and underlay to traffic, stairs, castors and cleaning needs. Carpet is unsuitable for persistently wet areas. Allow for seams, pattern direction and access when planning replacement.

Vacuum regularly, treat spills promptly with approved products and schedule periodic professional cleaning. Keep spare carpet tiles where local replacement is expected.

Concrete moisture, surface profile and coating compatibility are critical. Select the slip finish and chemical resistance for actual use. Many epoxies discolour in UV light; exterior exposure may require another system. Allow for ventilation, cure time and reopening limits.

Remove abrasive grit, clean with compatible products and repair coating damage early. Cleaning frequency and texture should suit the contamination expected.

Existing cracks, patches, joints and colour variation remain part of the result. Aggregate exposure cannot be guaranteed from a photograph. Distinguish mechanical polishing from grind-and-seal coatings and assess slip performance, stains and slab condition.

Use dust control and a compatible neutral cleaner, wipe up spills and maintain the specified guard or sealer. Avoid acidic products and neglected grit.